Hyundai Elantra: Body (Interior and Exterior)

Components and components location Components[Rear torsion beam disc brake type]1. Rear wheel speed sensor2. Rear wheel speed sensor connector[Rear multi link disc brake type]1...

Troubleshooting

Troubleshooting Symptom Passible Cause Remedy (Refer to page) Water leaks from panorama sunroofDeteriorated roof lid weatherstripReplaceExcessive roof lid - to - body clearance and improperly fitted weatherstripAdjustWind noise around sunroof Loose or deformed deflector, gaps in body workRetighten adjust or replac..

Other information:

Hyundai Elantra (CN7) 2021-2024 Owner's Manual: Air intake control

Recirculated air position With the recirculated air position selected, air from the passenger compartment will be drawn through the heating system and heated or cooled according to the function selected. Outside (fresh) air position With the outside (fresh) air position selected, air enters the vehicle from outside and is heated or cooled according to the function selected. Information..

Hyundai Elantra (CN7) 2021-2024 Service Manual: Rear Door Outside Handle

Components and components location Component Location 1. Rear door outside handle Repair procedures Replacement1.Remove the plug hole (A).2.Loosen the mounting screw (A) and then remove the rear door outside handle (B) by sliding it forward. Tightening torque : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)3.To install, reverse the removal procedure. ..

Tire Rotation

To equalize tread wear, HYUNDAI recommends that the tires be rotated according to the maintenance schedule or sooner if irregular wear develops.

During rotation, check the tires for correct balance.

When rotating tires, check for uneven wear and damage. Abnormal wear is usually caused by incorrect tire pressure, improper wheel alignment, out-ofbalance wheels, severe braking or severe cornering. Look for bumps or bulges in the tread or side of the tire. Replace the tire if you find any of these conditions. Replace the tire if fabric or cord is visible. After rotation, be sure to bring the front and rear tire pressures to specification and check lug nut tightness (proper torque is 79~94 lbf·ft [11~13 kgf·m]).