Hyundai Elantra Owners and Service Manuals

Hyundai Elantra: Body Side Molding / Front Mud Guard

Repair procedures
Replacement
   
When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Put on gloves to prevent hand injuries.
1.
After loosening the mounting screws and remove the front mud guard (A).

2.
To install, reverse the removal procedure.
   
Replace any damaged clips (or pin - type retainers).

    Rear Wheel Guard

    Repair procedures Replacement    • When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

    Rear Mud Guard

    Repair procedures Replacement    • When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

    Other information:

    Hyundai Elantra (CN7) 2021-2025 Service Manual: Water Inlet Fitting


    Repair procedures RemovalWater Inlet Fitting1.Remove the engine room under cover.(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")2.Drain the coolant. (Refer to Cooling System - "Coolant")3.Disconnect the radiator lower hose (A)...

    Hyundai Elantra (CN7) 2021-2025 Service Manual: Blower Motor


    Repair procedures Inspection1.Connect the battery voltage and check the blower motor rotation.Replacement1.Disconnect the negative (-) battery terminal.2.Disconnect the blower motor connector (A) and then remove the blower motor (B) after loosening the screws...

    Categories

    Steering wheel audio control

    The steering wheel audio control switches are installed for your convenience.

    NOTICE

    Do not operate audio remote control buttons simultaneously.

    VOLUME (VOL + / VOL -) (1)

    Move the VOLUME toggle switch up to increase volume. Move the VOLUME toggle switch down to decrease volume.

    read more

    Copyright © 2025 www.helantra7.com