Hyundai Elantra: Body (Interior and Exterior) / Body Side Molding

Rear Door Latch

Components and components location Component Location 1. Rear door latch Repair procedures Replacement1.Remove the rear door module.(Refer to Rear Door - "Rear Door Module")2...

Roof Side Molding

Repair procedures Replacement    • When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

Other information:

Hyundai Elantra (CN7) 2021-2025 Service Manual: Accelerator Position Sensor (APS)

Description and operation DescriptionAccelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power and ground line...

Hyundai Elantra (CN7) 2021-2025 Owner's Manual: Recommended Cold Tire Inflation Pressures

All tire pressures (including the spare) should be checked when the tires are cold. “Cold tires” means the vehicle has not been driven for at least three hours or has been driven for less than one mile (1.6 km). Warm tires normally exceed recommended cold tire pressures by 4 to 6 psi (28 to 41 kPa)...