Hyundai Elantra (CN7): Suspension System / Front Suspension System
Special Service Tools Tool (Number and Name) IIIustration Use 09546-3X100Shock absorber lock nut removal toolUsed for remove the shock absorber lock nut09568-1S100Ball joint removerSaperate the ball joint from the front alxe09551-AL100Rear torsion beam axle bush removal / installation toolRear torsion beam axle bush removal and installation tool
Components [A type]1. Front sub frame2. Front axle3. Front stabilizer bar4. Steering gearbox5. Front lower arm6. Front stabilizer bar link[B type]1. Sub frame2.
Other information:
Hyundai Elantra (CN7) 2021-2026 Service Manual: Ignition Switch Assembly. Repair procedures
Repair procedures Replacement1.Disconnect the negative (-) battery terminal.2.Remove the crash pad lower panel.(Refer to Body - "Crash Pad")3.Remove the steering column upper & Lower shroud.4.Remove the ignition switch and disconnecting the Key Warning / immobilizer connector.
Hyundai Elantra (CN7) 2021-2026 Service Manual: Mode Control Actuator
Description and operation DescriptionThe mode control actuator is located at the heater unit.It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- Auto Hold. Warning messages
- Suspension System
- Engine Control / Fuel System
- New on site
- Most important about car
