Hyundai Elantra Owners and Service Manuals

Hyundai Elantra: Warning and Indicator Lights / Master Warning Light

This indicator light illuminates:

When there is a malfunction in operation in any of the following systems:

-- Forward Collision-Avoidance Assist system malfunction (if equipped)
-- Forward Collision-Avoidance Assist radar blocked (if equipped)
-- Blind-Spot Collision Warning system malfunction (if equipped)
-- Blind-Spot Collision Warning radar blocked (if equipped)
-- High Beam Assist malfunction (if equipped)
-- Lamp malfunction (if equipped)
-- Smart Cruise Control malfunction (if equipped)
-- Tire Pressure Monitoring System (TPMS) malfunction (if equipped)

To identify the details of the warning, look at the LCD display.

    Low Fuel Level Warning Light

    This warning light illuminates: When the fuel tank is nearly empty. Add fuel as soon as possible. NOTICE Driving with the Low Fuel Level warning light on or with the fuel level below "E" can cause the engine to misfire and damage the catalytic converter...

    Low Tire Pressure Warning Light

    This warning light illuminates: • When you place the ignition in the ON position. -- It illuminates for approximately 3 seconds and then goes off...

    Other information:

    Hyundai Elantra (CN7) 2021-2024 Service Manual: Rear Coil Spring


    Components and components location Components1. Coil spring upper pad2. Rear coil spring3. Coil spring lower pad Repair procedures Removal1.Loosen the wheel nuts slightly.Raise the vehicle, and make sure it is securely supported.2.Remove the rear wheel and tire (A) from the rear hub...

    Hyundai Elantra (CN7) 2021-2024 Service Manual: Oil Filter & Oil Cooler


    Repair procedures Removal and Installation1.Disconnect the battery negative terminal.2.Remove the engine room under cover.(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") 3.Drain the coolant.(Refer to Cooling System - "Coolant")4...

    Categories

    Manual climate control system

    To defog inside windshield

    [A] : Type A, [B] : Type B

    1. Select any fan speed except “0” position.

    2. Select the desired temperature.

    3. Select the or position.

    read more

    Copyright © 2024 www.helantra7.com