Hyundai Elantra: Air Bag - Advanced Supplemental Restraint System / Why Didn’t My Air Bag Go Off in a Collision?
Air bags are not designed to inflate in
every collision. There are certain types
of accidents in which the air bag would
not be expected to provide additional
protection. These include rear impacts,
second or third collisions in multiple
impact accidents, as well as low speed
impacts. Damage to the vehicle indicates
a collision energy absorption, and is not
an indicator of whether or not an air bag
should have inflated.
WARNING
To reduce the risk of an air bag
deploying unexpectedly and causing
serious injury or death:
- Do not hit or allow any objects to
impact the locations where air bags
or sensors are installed.
- Do not perform maintenance on or
around the air bag sensors. If the
location or angle of the sensors is
altered, the air bags may deploy
when they should not or may not
deploy when they should.
- Do not install bumper guards or
replace the bumper with a nongenuine
HYUNDAI parts. This may
adversely affect the collision and air
bag deployment performance.
- Place the ignition switch in the
LOCK/OFF or ACC position when the
vehicle is being towed to prevent
inadvertent air bag deployment.
- Have all air bag repairs conducted by
an authorized HYUNDAI dealer.
Your vehicle is equipped with an
Occupant Classification System (OCS) in
the front passenger’s seat.
Main components of the Occupant
Classification System
A detection device located within the
front passenger seat cushion...
1. SRS control module/Rollover sensor
2. Front impact sensors
3. Side impact sensors (acceleration)
4. Side impact sensors (pressure)..
Other information:
Component Location[Engine Room]1. Engine room junction block[Interior Relay]1. ICU (Integrated Central Control Unit)..
Repair procedures
Removal1.Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump")2.Disconnect the fuel pump motor connector (A) and fuel sender connector (B).3.Release the fixing hook (A) and then remove the fuel sender (B).4.Remove the fixing clip (A) and then disconnect the fuel feed tube (B).5.Remove the fixing clip (A) and then remove the head assembly (B).6.Release the fixing ..