Hyundai Elantra: Driveshaft and axle / Special service tools

Hyundai Elantra (CN7) 2021-2024 Service Manual / Driveshaft and axle / Special service tools

Special Service Tools

Tool (Number and Name)	Illustration	Use
09495-3K000 Band installer		Installation of ear type boot band
09495-39100 Band installer		Installation of hook type boot band
09568-1S100 Ball joint puller		Remove the ball joint front axle
09495-33000 Puller		Remove the spider assembly from the drive shaft

Specifications

Specification Engine Transmission Joint type Max...

Front Axle Assembly. Front Hub / Knuckle / Tone Wheel

Other information:

Hyundai Elantra (CN7) 2021-2024 Service Manual: Rear Bumper beam Assembly

Components and components location Component Location1. Rear bumper beam assembly Repair procedures Replacement • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.• Put on gloves to protect your hands. • ..

Hyundai Elantra (CN7) 2021-2024 Owner's Manual: Aluminum wheel maintenance

The aluminum wheels are coated with a clear protective finish. NOTICE Do not use abrasive cleaner, polishing compound, solvent, or wire brushes on aluminum wheels. Clean the wheel when it has cooled. Use only a mild soap or neutral detergent, and rinse thoroughly with water. Also, clean the wheels after driving on salted roads. Do not wash the wheels with highspeed car wash brush..

Side air bags

Front seat

Your vehicle is equipped with a side air bag in each front seat. The purpose of the air bag is to provide the vehicle’s driver and the front passenger with additional protection than that offered by the seat belt alone.