Hyundai Elantra: Important Safety Notice / General information
Proper service methods and repair procedures are essential for safe, reliable operation of all motor vehicles as well as personal safety of the operator. The service procedures and descriptions in this shop manual provide general directions for service and repair.
There are various procedures, techniques, tools and pars for service as well as the skill of technicians.
Therefore, it is impossible for this manual to provide advice or caution for each case.
Accordingly, if you use a replacement part, service procedure, or tool which are not recommended by the vehicle manufacturer, make sure that neither the personal safety nor the safe operation of the vehicle is jeopardized.
| •
| Reminds you to be especially careful in those areas where carelessness will cause death or serious injury. |
|
| •
| Reminds you to be especially careful in those areas where carelessness may cause death or serious injury. |
|
| •
| Reminds you to be especially careful in those areas where carelessness may cause personal injury. |
|
| •
| Gives you information that will prevent you from making errors that could damage the vehicle. |
|
| •
| Gives you additional information that will help you complete a particular procedure. |
|
The following list contains some general WARNINGS that you should follow while working on a vehicle.
| •
| Always wear safety glasses for eye protection. |
| •
| Use safety stands whenever a procedure requires you to be under the vehicle. |
| •
| Make sure that the ignition switch is always in the OFF position, unless otherwise required by the procedure. |
| •
| Set the parking brake when working on the vehicle. If you have an automatic transaxle, set the vehicle in the P position. |
| •
| Place supporters against the front and rear surfaces of the tires to prepare for the vehicle suddenly moving. |
| •
| Operate the engine only in a well-ventilated area to avoid the danger of carbon monoxide poisoning. |
| •
| Keep yourself and your clothing away from moving parts when the engine is running, especially the drive belts. |
| •
| To prevent serious burns, avoid contact with hot metal parts such as the radiator, exhaust manifold, tail pipe, catalytic converter and muffler. |
| •
| Do not smoke while working on a vehicle. |
| •
| To avoid injury, always remove rings, watches, loose hanging jewelry, and loose clothing before beginning to work on a vehicle. |
| •
| When it is necessary to work under the hood, keep hands and other objects clear of the radiator fan blades! Your vehicle may be equipped with a cooling fan that may turn on, even though the ignition switch is in the OFF position. For this reason care should be taken to ensure that the radiator fan electric motor is completely disconnected when working under the hood and that the engine is not running. |
Other information:
Components and components location
Component Location [This illustration shows the LHD type. RHD type is symmetrical.]1. Steering column shroud upper panel2. Steering column shroud lower panel
Repair procedures
Replacement[Steering column shroud upper panel]
•
When removing with a flat - tip screwdriver or remover, wrap protective tape around ..
Curtain air bags are located along both
sides of the roof rails above the front and
rear doors.
They are designed to help protect the
heads of the front seat occupants and
the rear outboard seat occupants in
certain side impact collisions.
The curtain air bags are designed to
deploy during certain side impact
collisions, depending on the crash
severity.
The side and curtain air bags on b..
