Hyundai Elantra: Manual Climate Control System / System operation
Ventilation
1. Select the Face Level
mode.
2. Set the air intake control to fresh
mode.
3. Set the temperature control to the
desired position.
4. Set the fan speed control to the
desired speed.
Heating
1. Select the Floor Level
mode.
2. Set the air intake control to fresh
mode.
3. Set the temperature control to the
desired position.
4. Set the fan speed control to the
desired speed.
5. If desired, turn the air conditioning ON
with the temperature control knob set
to heat in order to dehumidify the air
before it enters into the cabin.
If the windshield fogs up, select the Floor
& Defrost
mode or rotate the mode
selecting knob to the Defrost
mode.
Operation Tips
- To help keep dust or unpleasant fumes
from entering the vehicle through the
ventilation system, temporarily set the
air intake control to the recirculation
mode. Be sure to return the control
to fresh mode position when the
irritation has passed to keep fresh air
in the vehicle. This will help keep the
driver alert and comfortable.
- To help prevent interior fog on the
windshield, set the air intake control
to fresh mode and fan speed to
the desired position, turn on the
air conditioning system, and adjust
the temperature control to desired
temperature.
Fan speed control
Turn the knob to the right to increase
the fan speed and airflow. Turn the knob
to the left to decrease fan speed and
airflow.
Setting the fan speed control knob to the
“0” position turns off the fan...
HYUNDAI Air Conditioning Systems are
filled with R-1234yf refrigerant.
1. Start the vehicle.
2. Push the air conditioning button
3. Select the Face Level mode...
Other information:
Repair procedures
Replacement
•
Be careful not to scratch the hood panel. 1.Using a clip remover, remove the clips and then the hood insulator pad (A).2.To install, reverse the removal procedure.
•
Replace any damaged clips (or pin - type retainers)...
Component Location (1)1. Smart key unit (IBU)2. Interior antenna 23. Door outside handle4. Interior antenna 15. BuzzerComponent Location (2)1. Trunk open switch2. Bumper antenna3. Trunk atenna..