Hyundai Elantra: Horn / Repair procedures

Hyundai Elantra (CN7) 2021-2025 Service Manual / Body Electrical System / Horn / Repair procedures

Removal

1.	Remove the front bumper cover. (Refer to Body - "Front Bumper Cover")

2.	Remove the bolts and disconnect the horn connectors (A), then remove the horn (B). [Low pitch] [High pitch]

Installation

1.	Install the horns after connect the horn connectors.

2.	Install the front bumper cover.

Components and components location

C..

Audio

Other information:

Hyundai Elantra (CN7) 2021-2025 Service Manual: Intake Actuator

Description and operation DescriptionThe intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes. Components and components location Components Location1. Intake actuator Specifications Specifications Door position ..

Hyundai Elantra (CN7) 2021-2025 Service Manual: Troubleshooting

Failure Diagnosis1.In principle, ESP and TCS controls are prohibited in case of ABS failure.2.When ESP or TCS fails, only the failed system control is prohibited.3.However, when the solenoid valve relay should be turned off in case of ESP failure, refer to the ABS fail-safe.4.Information on ABS fail-safe is identical to the fail-safe in systems where ESP is not installed.Memory of Fail Code1.It ke..

Rear center seat belt

When using the rear center seat belt, the buckle with the “CENTER” mark must be used.

WARNING

Make sure that the seatback is locked in place when using the rear center seat belt.

If not, the seatback may move when there is a sudden stop or collision, which could result in serious injury.