Hyundai Elantra: Towing / Removable towing hook
1. Open the trunk, and remove the
towing hook from the tool case.
2. Remove the hole cover by pressing
the lower part of the cover on the
bumper.
3. Install the towing hook by turning it
clockwise into the hole until it is fully
secured.
4. Remove the towing hook and install
the cover after use.
Towing Service
If emergency towing is necessary,
we recommend having it done by
an authorized HYUNDAI dealer or a
commercial tow-truck service.
Proper lifting and towing procedures
are necessary to prevent damage to
the vehicle...
Front
Rear
If towing is necessary, we recommend
you have it done by an authorized
HYUNDAI dealer or a commercial tow
truck service.
If towing service is not available in
an emergency, your vehicle may be
temporarily towed using a cable or chain
secured to the emergency towing hook
at the front (or rear) of the vehicle...
Other information:
Components and components location
Components1. Water pump pulley2. Water pump 3. Water pump gasket
Repair procedures
Removal1.Remove the engine room under cover.(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")2.Drain the coolant...
Components and components location
Component Location [This illustration shows the LHD type. RHD type is symmetrical.]1. Steering column shroud upper panel2. Steering column shroud lower panel
Repair procedures
Replacement[Steering column shroud upper panel]
•
When removing with a flat - tip screwdriver or remover, wrap protective tape around ..