Hyundai Elantra Owners and Service Manuals

Hyundai Elantra: Smart Key / Loss of a smart key & Smart key precautions

Loss of a smart key

A maximum of two Smart Keys can be registered to a single vehicle. If you happen to lose your smart key, you should immediately take the vehicle and remaining keys to your authorized HYUNDAI dealer or tow the vehicle, if necessary.

Smart key precautions

The smart key may not work if any of the following occur:

  • The smart key is close to a radio transmitter such as a radio station or an airport which can interfere with normal operation of the transmitter.
  • The smart key is near a mobile two way radio system or a cellular phone.
  • Another vehicle’s smart key is being operated close to your vehicle.

If the smart key does not work correctly, open and close the door with the mechanical key. If you have a problem with the smart key, contact an authorized HYUNDAI dealer.

If the smart key is in close proximity to your mobile phone, the signal could be blocked by your mobile phone’s normal operational signals. This is specifically relevant when the phone is active such as making and receiving calls, text messaging, and/or sending/receiving emails. When possible, avoid keeping the smart key and your mobile phone in the same location such as a pants or jacket pocket in order to avoid interference between the two devices.

Information

This device complies with Part 15 of the FCC rules.

Operation is subject to the following three conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation.

3. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the device.

NOTICE

Keep the smart key away from electromagnetic materials that blocks electromagnetic waves to the key surface.

    Mechanical key

    If the Smart Key does not operate normally, you can lock or unlock the driver’s door by using the mechanical key. Press and hold the release button (1) and remove the mechanical key (2)...

    Battery replacement

    If the Smart Key is not working properly, try replacing the battery with a new one. Battery Type: CR2032 To replace the battery: 1. Remove the mechanical key...

    Other information:

    Hyundai Elantra (CN7) 2021-2024 Service Manual: Blower Unit


    Components and components location Component Location1. Blower unit assemblyComponents1. Blower unit assebmly2. Blower upper cover [LH]3. Duct seal4. Blower upper cover [RH]5. Intake actuator6. Air filter cover7. Intake door8. Air filter9. Blower upper case10...

    Hyundai Elantra (CN7) 2021-2024 Service Manual: Repair procedures


    Removal1. Remove the front bumper cover.(Refer to Body - "Front Bumper Cover")2.Remove the bolts and disconnect the horn connectors (A), then remove the horn (B).[Low pitch][High pitch]Installation1. Install the horns after connect the horn connectors...

    Categories

    Function malfunction and limitations

    Function malfunction

    When High Beam Assist is not working properly, the ‘Check High Beam Assist (HBA) system’ or ‘Check HBA (High Beam Assist) system’ warning message will appear and warning light will illuminate on the cluster. Take your vehicle to an authorized HYUNDAI dealer and have the function checked.

    read more

    Copyright © 2024 www.helantra7.com