Hyundai Elantra: Manual Climate Control System / Heating and Air Conditioning
1. Start the engine.
2. Set the mode to the desired position. To improve the effectiveness of heating and cooling, select the mode according to the following:
-- Heating: .png)
-- Cooling: .png)
3. Set the temperature control to the desired position.
4. Set the air intake control to fresh mode or recirculation mode position.
5. Set the fan speed control to the desired speed.
6. If air conditioning is desired, turn the air conditioning system on.
When starting the vehicle in cold weather a more efficient way to heat the passenger compartment is to do the following.
-- Turn off or lower the blower, right after starting the engine.
• Engine temperature is still low and the air flow from the heater is still cold.
-- After a few minutes of engine warm up, turn on or set the fan to a higher level and adjust the temperature setting towards hot.
Manual Climate Control System
Type A
Type B
1. Fan speed control knob
2. Temperature control knob
3. Mode selection knob
4. Front windshield defroster position
5. Rear window defroster button
6...
Mode selection
The mode selection knob controls the
direction of the air flow through the
ventilation system.
Air can be directed to the floor,
dashboard outlets, or windshield...
Other information:
Hyundai Elantra (CN7) 2021-2025 Service Manual: Audio Unit
Components and components location ComponentsAudioConnector Pin Information No Connector A Connector B 1Rear left speaker (+)MM_CAN High2Front left speaker (+)-3Front right speaker (+)-4Rear right speaker (+)Steering wheel remote5--6Door openUSB DATA (+)7IGN1USB VOC8Illumination (+)-9Detent-10Rear left s..
Hyundai Elantra (CN7) 2021-2025 Service Manual: Rear Glass Defogger Printed Heater
Repair procedures Inspection • Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply finger pressure on the tin foil, moving the tin foil along the grid line to check for open circuits.1.Turn on the defogger switch and use a voltmeter to measure the voltage of each heater line at the glass center point. If a..
Categories
- Manuals Home
- 7th Gen Hyundai Elantra Owners Manual
- 7nd Gen Hyundai Elantra Service Manual
- Engine Oil
- System operation
- Engine Mechanical System
- Interior Overview
- Maintenance
Tire Rotation
To equalize tread wear, HYUNDAI recommends that the tires be rotated according to the maintenance schedule or sooner if irregular wear develops.
During rotation, check the tires for correct balance.
When rotating tires, check for uneven wear and damage. Abnormal wear is usually caused by incorrect tire pressure, improper wheel alignment, out-ofbalance wheels, severe braking or severe cornering. Look for bumps or bulges in the tread or side of the tire. Replace the tire if you find any of these conditions. Replace the tire if fabric or cord is visible. After rotation, be sure to bring the front and rear tire pressures to specification and check lug nut tightness (proper torque is 79~94 lbf·ft [11~13 kgf·m]).
