Hyundai Elantra: Intelligent variable transmission / Good driving practices
- Never move the shift lever from P
(Park) or N (Neutral) to any other
position with the accelerator pedal
depressed.
- Never move the shift lever into P
(Park) when the vehicle is in motion.
- Be sure the vehicle is completely
stopped before you attempt to shift
into R (Reverse) or D (Drive).
- Do not move the shift lever to N
(Neutral) when driving. Doing so
may result in an accident because
of a loss of engine braking and the
transmission could be damaged.
- When driving uphill or downhill,
always shift to D (Drive) for driving
forward or shift to R (Reverse) for
driving backwards, and check the
gear position indicated on the cluster
before driving. Driving in the opposite
direction of the selected gear, can
lead to a dangerous situation by
shutting off the engine and affecting
the braking performance.
- Do not drive with your foot resting
on the brake pedal. Even light, but
consistent pedal pressure can result
in the brakes overheating, brake wear
and possibly even brake failure.
- Do not hold the vehicle on an incline
with the accelerator pedal. This can
cause the transmission to overheat.
Always use the brake pedal or parking
brake.
- Always apply the parking brake when
leaving the vehicle. Do not depend on
placing the transmission in P (Park) to
keep the vehicle from moving.
- Exercise extreme caution when
driving on a slippery surface. Be
especially careful when braking,
accelerating or shifting gears. On a
slippery surface, an abrupt change
in vehicle speed can cause the drive
wheels to lose traction and may cause
loss of vehicle control resulting in an
accident.
- Optimum vehicle performance and
economy is obtained by smoothly
depressing and releasing the
accelerator.
WARNING
To reduce the risk of SERIOUS INJURY
or DEATH:
- ALWAYS wear your seat belt. In a
collision, an unbelted occupant
is significantly more likely to be
seriously injured or killed than a
properly belted occupant.
- Avoid high speeds when cornering or
turning.
- Do not make quick steering wheel
movements, such as sharp lane
changes or fast, sharp turns.
- The risk of rollover is greatly
increased if you lose control of your
vehicle at highway speeds.
- Loss of control often occurs if two or
more wheels drop off the roadway
and the driver over steers to reenter
the roadway.
- In the event your vehicle leaves
the roadway, do not steer sharply.
Instead, slow down before pulling
back into the travel lanes.
- HYUNDAI recommends you follow all
posted speed limits.
Always come to a complete stop and
continue to depress the brake pedal.
Move the shift lever into the P (Park)
position, apply the parking brake, and
place the ignition switch in the LOCK/
OFF position...
Power Brakes
Your vehicle has power-assisted brakes
that adjust automatically through normal
usage.
If the engine is not running or is turned
off while driving, the power assist for
the brakes will not work...
Other information:
Repair procedures
Removal1.Disconnect the negative (-) battery terminal.2.Remove the front seat assembly.(Refer to Body - "Front Seat Assembly")3.Remove the seat back.(Refer to Body - "Front Seat Back Cover")4.Disconnect the lumber support motor connector (A)...
Components and components location
Components Location1. Front seat belt buckle
Repair procedures
Replacement1.Remove the front seat assembly.(Refer to Front Seat - "Front Seat Assembly")2.Disconnect the front seat belt buckle connector wiring (A)...